1. Wholesale china Vacuum magnetic valve First check whether the solenoid valve is consistent with the selection parameters, such as power supply voltage, medium pressure, pressure difference, etc., especially the power supply. If you make a mistake, the coil will be burned.

2. Before taking over the pipe, the pipe should be flushed to remove the metal powder, sealing material residue, rust, etc. in the pipe.

3. Generally, the electromagnetic coil parts of Wholesale china Vacuum magnetic valve should be vertically upward and installed vertically on the pipeline horizontal to the ground. If it must be installed sideways due to space constraints or working conditions, it must be proposed when selecting and ordering.

4. A manual cut-off valve should be installed before and after the solenoid valve, and a bypass should be set at the same time to facilitate maintenance of the solenoid valve when it fails.

5. Wholesale china Vacuum magnetic valve is generally directional and cannot be installed reversely. Usually, → is used on the valve body to indicate the flow direction of the medium. When installing, it must be installed in the direction indicated by →.

6. If the medium will cause water hammer, then a solenoid valve with water hammer function should be selected or corresponding preventive measures should be taken.

7. Try not to keep the Wholesale china Vacuum magnetic valve in the energized state for a long time, which will easily reduce the service life of the coil or even burn the coil. That is to say, the normally open and normally closed solenoid valves cannot be used interchangeably.

8. A steam trap should be installed on the inlet side of the solenoid valve for steam, and the connecting pipe should be inclined.