Do you understand the installation knowledge of vacuum pumps? Let's follow the editor of china Two stage vacuum pump supplier to have a simple understanding!
1. The vacuum pump should be installed in a place where the ground is strong and firm, and there should be sufficient room around it to facilitate inspection, maintenance and maintenance.
2. Keep the foundation level under the base of the vacuum pump. It is recommended to pad the four corners of the base with shock-absorbing rubber or cast and install with bolts to ensure smooth operation of the vacuum pump and low vibration.
3. The connection pipeline between the vacuum pump and the system should be sealed and reliable. For small vacuum pumps, metal pipelines can be used to connect the gaskets and oil-resistant rubber, for small vacuum pumps, vacuum hoses can be used for connection. Short and few elbows.
4. In the connecting pipeline, the user can install a valve and a vacuum gauge above the air inlet of the vacuum pump to check the ultimate pressure of the vacuum pump at any time.

5. Connect the power supply according to the motor label, and install the grounding wire and fuse and thermal relay of appropriate specifications.
6. When the vacuum pump is energized for trial operation, the motor belt must be removed and the vacuum pump can be put into use after confirming that the steering of the vacuum pump is in accordance with the specified direction to prevent the vacuum pump from reversing and spraying.
7. For vacuum pumps with cooling water, connect the cooling water as required.
8. When a solenoid valve is installed at the vacuum pump port, the valve and the vacuum pump should act at the same time.
9. When the exhaust gas from the vacuum pump affects the working environment, a pipe can be installed at the exhaust port to lead away or an oil mist filter can be installed.
In summary, the editor of china Two stage vacuum pump supplier tells: Introduction to the installation knowledge of vacuum pumps.